The latest “BAD” version is Software Version: 8.0.213.0 / Last Update: The driver seems problematic, and it does not come with any programming software. The hardware should be displayed, if not get the driver software … Power off your system completely,(including PSU power) –basically you want to hardware reset the USB Bus, and it will enumerate again once windows boots. In which case:Ĭlick on the error shown in this list, and select remove device. You will see a list, and on it somewhere near the bottom, will be (if you are lucky and drivers are good) “X52 H.O.T.A.S (HID) X52 H.O.T.A.S (USB)Īlternatively, you may have got an error when you plugged in your X52, as I did saying the device was not set up properly. Select “Hardware and Sound”, then select “Device Manger”įrom there, click and expand “Human Interface Devices” I ran control panel, went into device manager: – This was my starting point, completely Non-functional. Sometimes, it will appear as unknown device, so you cannot even change it to Generic USB. Often they simply will not detect the X52, unless you manually change it in device manager to Generic USB device.

The problem is then compounded by the fact that the new Logitech drivers, come with their own set of issues. I used to use the “Madcatz” software, but that doesn’t work, and will not detect the X52 under win10, and USB3 (well not in my case anyway). Firstly, some of the solutions you see, which are correct, talk about the programming software / grid view, joystick icon on the notification area. So I finally put a bit of time into this to try to figure it out, and got the solution. I had this working, but for some reason, it does not (or rather did not) work with new Logitech drivers for Win10.

For all you pilots out there who are having issues with the pinkie switch.

Logitech x52 elite dangerous profile